How to Ram an Induction Furnace Lining, Step by Step
A practical walk-through of ramming a coreless induction furnace with silica ramming mass, from coil check to topping.
Every furnace maker and every shop has its own detailed procedure, and that procedure comes first. This is the general sequence most melt shops follow.
1. Inspect the coil and coil grout
Check the coil for damage and leaks, and make sure the coil grout or cement is sound and dry. Clean out old lining material completely.
2. Fit the insulation layer
Most shops place a thin insulating or slip layer, such as mica sheet or insulation board, against the coil grout. It helps the lining move as it heats and protects the coil.
3. Ram the bottom
Pour the mass in even layers and compact each one with forks, rammers or a vibrator before adding the next. Thin layers rammed well beat thick layers rammed in a hurry.
4. Place the former
Set the steel former exactly in the centre and level. An off-centre former gives a thin wall on one side, and the thin side fails first.
5. Ram the side walls
Fill the gap around the former in layers, compacting each one and working all the way round. De-air the mass as you go so no pockets remain.
6. Top and spout
Finish the top with the topping or nali top material your shop uses, shaping the spout area carefully.
7. Sinter
Leave the former in place and start the first heat with a clean charge, following the sintering schedule for your grade.
Habits that pay off
- Keep every bag dry and use it soon after opening.
- Do not let foreign material, metal pieces or scale fall into the mass.
- Record each relining: grade, binder, layers, time and campaign life. Patterns appear quickly.