Sintering a New Silica Lining: Why the First Heat Matters
The first heat decides how strong a new induction furnace lining becomes. Learn what happens during sintering and how to plan it.
A freshly rammed lining is only compacted powder. It becomes a working wall during the first heat, when the hot face sinters. A rushed first heat is one of the most common reasons for short lining life.
What happens as temperature rises
- Remaining moisture leaves first.
- With a boric acid binder, the acid loses its water and turns into boron oxide.
- Boron oxide reacts with the silica and forms a glassy phase that bonds the grains at the hot face.
- At full temperature the hot face densifies into a hard sintered layer.
The shape of a good schedule
Your supplier's chart for the grade comes first. Most schedules share the same shape:
- A slow start, so moisture and gases can escape without cracking the wall.
- One or more holds at intermediate temperatures.
- A steady rise to full operating temperature.
- A hold at or a little above normal tapping temperature, so the sintered layer reaches a useful depth.
The former and the first charge
The steel former is usually left in and melts with the first charge. Use clean, dry, known scrap for the first melts, and avoid heavy pieces that can hit the soft new wall.
Mistakes to avoid
- Heating too fast at the start.
- Stopping and restarting during sintering.
- Charging wet or rusty scrap.
- Running cold for long periods after the first heat.
A patient first heat is cheap compared with an early reline.