What Is Silica Ramming Mass? A Plain Guide for Melt Shops
Silica ramming mass is the dry quartz lining of a coreless induction furnace. Learn what it is made of, how it works and where it is used.
Silica ramming mass is a dry refractory made from high-purity quartz or quartzite, crushed and graded into a careful mix of grain sizes, with a small amount of binder. It is the material that forms the working lining of most coreless induction furnaces that melt steel and cast iron.
Why it is called "ramming" mass
The mass is installed dry. It is poured into the gap between the furnace coil and a steel former, then rammed or vibrated layer by layer until the grains lock together. There is no water and no mortar. The lining gets its strength later, from heat.
What it is made of
- Quartz or quartzite with a very high silica (SiO₂) content, usually well above 98% in good grades.
- A planned grain size distribution, from a few millimetres down to fine flour, so the grains pack with as few gaps as possible.
- A binder, most often boric acid or boron oxide, that helps the hot face sinter during the first heat.
How it works in the furnace
On the first heat the side touching the metal sinters into a hard, glassy layer. Behind it the mass is only partly bonded, and at the back, next to the coil, it stays loose. That loose back layer is useful: it cushions the coil and stops cracks from running straight through the wall.
Where it is used
Silica is an acidic refractory, so it suits melting of mild steel, carbon steel and cast iron, where slags are acidic or neutral. Steel in an induction furnace is typically tapped somewhere around 1,600 to 1,700 °C, and a well-made silica lining is designed to hold that back heat after heat.
Choosing a grade
The right grade depends on furnace size, what you melt, your sintering practice and how often you reline. A supplier should be able to share the grading, silica content and recommended binder level for each grade.
Talk to us about your furnace and we will suggest a grade to start with.